Which Length Lag Screw to use to join two pieces.
I figure a picture will explain what I am trying to do better:
What length coach screw (lag screw) would be best? I am not too sure how far into the plywood I should be going. Or which diameter to get. I want to hold the plywood section tight to the section underneath. I want it to be as secure as possible, but I don't want any visible screws from the top.
Would like some advice also on pilot holes.
Submitted October 10, 2015 at 08:34PM by hateball
via reddit http://ift.tt/1jVCKl9